Micanan PRO-H Instruction Manual download pdf (Page 19)

Secondary non-monitored safety device(s):

A standard 2-wire safety edge, non-monitored photo beams or any other non-monitored reversing devices with a

N.O contact can be connected to terminals S1 and S2 as secondary non-monitored safety device.

Note: More than one secondary non-monitored safety device can be connected to terminals S1 and S2.

Important: Do not remove the resistor that is factory installed across terminals S1 and S2 unless installing a 4-wire electric

edge.

4-wire electric edge:

A standard 4-wire electric edge can be connected across S1 and S2 terminals as a secondary safety device.

Remove the factory-installed resistor across terminals S1 and S2 when using a 4-wire electric edge

CONNECTION OF EXTERNAL SINGLE-BUTTON DEVICE

Connect an external single-button as shown in diagram. Please refer to ‘’Modes of operation’’ for the functionality of single-

button.

MODES OF OPERATION

All operators leave the factory in the D1 mode setting; please read all modes of Operation and determine which operational

mode is desired

B2: (Momentary on open and close)

• Open Button: Momentary activation opens the door. When door is closing, momentary activation reverses the door (OPEN

OVERRIDE). Momentary contact from mid-stop opens the door to full open position. Constant activation when door is

opening, bypass mid-stop if enabled.

• Close button: Momentary on close.

• Stop button: Momentary activation stops the door.

• Single button device and single channel transmitter, 3-channel (1,2,3) transmitter:

SEQ FUNCTION: Open/Stop/Close/Reverse.

COMMERCIAL FUNCTION: Open/Close/Reverse.

• 3-button O/C/S radio transmitter: Same as open, close, stop buttons.

• Safety Devices: When door is closing, momentary activation reverses the door.

• Timer to close: N/A

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

No comments

Micanan PRO-H Instruction Manual Page 19